COP Security 15-VT08-CDRW Manual de usuario descargar pdf (Pagina 44)

5-2 PTZ

To make the PTZ camera function correctly, please follow the instructions below:

1. Connect the PTZ to RS232 port (via RS485-RS232 converter).

2. Refer to Chapter 5-7-2 to assign “PTZ” to the RS232 port you connected.

3. Refer to the user manual of PTZ to setup the protocol, baud rate and ID.

4. Select Camera: please select the correct camera number which has PTZ function.

5. Status: set to ”Enable”

6. Model, ID, and Baud Rate: set the ID the same as the PTZ camera.

You can control the PTZ camera using the control panel in this page.

: Focus near

: Focus far

: auto focus

Preset function:

1. Select p1reset point 1.

2. Move the PTZ camera to the position 1 using the panel.

3. Click “save”.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 115 116

Sin comentarios

COP Security 15-VT08-CDRW Manual de usuario Pagina 44